Hardwood Installation in Thompson’s Station, TN
Taking up the bedroom carpet? Adding hardwood to a family room? Start with the floor you already like. We’ll help you match the boards, plan the doorway or stair connection, and figure out how much of the existing floor can stay.

Bedroom hardwood from McGrath’s Hartog project in Franklin.
Three ways to connect the new floor
Look at the first place the floors meet. A bedroom door, an open kitchen, and the top of a stair can each call for a different detail.
Start with the original flooring
Check the builder’s selection sheet or a leftover carton for the species, collection, and finish. At a floor register we can often inspect a board’s thickness and edge profile. Check samples next to the existing floor in daylight and again with the lights on. Older boards and new stock can look different even when the product name matches.
Consider weaving in new boards
Where compatible boards can be joined, staggered board ends can carry the pattern into the new room. New and old wood may still take stain differently. We’ll look at the existing floor’s condition and test the finish together so you can see what a blend would involve before expanding the scope.
Give changes in direction or height a clear edge
If the original boards are unavailable, run a different direction, or sit at a different height, a deliberate transition at a doorway may be the cleanest choice. At a stair landing, plan the nosing and finished floor height before ordering planks.

The Hartog project in Franklin shows a separate McGrath project. We replaced selected hickory boards and refinished the surrounding floors and stair treads.
A bedroom match in Canterbury
After nine years in her home, Canterbury homeowner Lynn F. wanted to add hardwood to the bedroom. She said Julie helped her find a match for the wood she already had, and she praised the crew who installed it.

Manufacturer room scene. Garrison’s Allora Volto 7½-inch oak.
Two samples for two different jobs
Mercier Origins Red Oak Natural. If you’re matching an existing narrow red oak strip, Mercier lists solid boards in 2¼, 3¼, and 4¼ inches. Bring your current board or its measurements and compare the grain, edge, and sheen. See Mercier’s widths and finishes.
Garrison Allora Volto. If you’re replacing the hardwood across a connected living area, look at a wider sample as well. Volto is a 7½-inch engineered European oak with a matte lacquer finish. Compare several planks together to see how the natural variation reads across the room. We’ll confirm the selected product and installation method for your subfloor.
What happens before we order the wood
Show us the junction
Share photos from both sides of the doorway or landing, plus a photo of a spare board or carton label if you have one.
Inspect the existing floor
We check plank dimensions and profile, the subfloor, and moisture conditions at the site.
Review samples in the room
Set the selected boards next to the floor you’re keeping. Discuss finish, direction, trim, and what would need to be refinished.
Set the work schedule
Review the scope for removal, prep, installation, and any site finishing. Decide which rooms or stairs need to remain accessible.
Questions before you start
We can look for a compatible board using the species, width, thickness, profile, and finish. If we can’t find a good fit, we can compare a finish blend with a deliberate threshold.
That depends on the join and the condition of the existing finish. We’ll compare doing the new room on its own with blending the adjacent wood. The scope should say exactly where any sanding and finishing stops.
We’ll check slab moisture and flatness and compare engineered options approved for the location. We also check the full installed height before choosing the doorway transition or ordering trim.
Bring the board you want to match
Visit our Franklin showroom with a spare plank, a carton label, or photos of the doorway. Tell us what you’re keeping and which rooms you’d like to change so we can plan the next step together.
